|
The Marlow Range of Stainless Steel Wire Balustrade with Wooden Posts
(All the wire and fittings are marine grade stainless steel.)
IF YOU HAVE ANY QUESTIONS ON YOUR WIRE BALUSTRADE, PLEASE CONTACT US ON 01628 526995.
DUE TO THE NUMBER OF VARIATIONS, THIS PRODUCT IS NOT AVAILABLE TO BE PURCHASED DIRECTLY FROM THIS SITE. PLEASE SEND YOUR REQUIREMENTS TO US BY EMAIL (htfenceanddecking@btconnect.com) OR FAX (01628 522541) OR TEL (01628 526995). WE DO NOT SUPPLY WOOD POSTS WHICH ARE AVAILABLE AT YOUR LOCAL TIMBER YARD OR WAREHOUSE SHED. PAYMENT WILL BE TAKEN BY CREDIT CARD.
The Stainless Steel Wire must be connected in straight lines. The wire can pass through intermediate newel posts. The wire is joined to the newel posts by an End Fixing Unit. The End Fixing Unit consists of a Dual Headed Screw, Lock Nut and Inside Thread Connector which is clamped (swaged) onto the wire.
A Tensioner is required if the wire length exceeds 4 metres. Two tensioners are required if the wire length exceeds 15 metres. The maximum length is 25m for a single run. The Tensioner will replace the Inside Thread Connector at one end with the addition of a Threaded Stud and extra lock nut.
See our Step by Step Stainless Steel Wire Balustrade with Wood Posts Assembly Instructions for straight runs and steps.
The Marlow Range of Stainless steel wire balustrade can be installed on either level decking or steps.
| Produce |
Price per unit £ inc. VAT |
. |
| End Fixing Unit plus clamping onto wire. These are supplied with a left and right screw so that they can be tightened when in position. |
£17.95 |
Dual Thread Screw, Lock Nut,
Inside Thread Connector clamped to Wire.
|
| 4mm Stainless Steel 1 x 19 Wire |
£1.76 per metre |
 |
| Tensioner Assembly Unit |
£21.07 |
Dual Thread Screw, Nut, Tensioner, Nut,
Threaded Stud clamped to Wire.
|
ORDERING STAINLESS STEEL WIRE
A sketch of your balustrading requirements would be very useful. You may place your order by email, fax or telephone (see top of page).
In order to make the correct lengths of wire, we will need your requirements for each section.
|
Section * |
No. of wires per section |
Wire length (mm.) |
End fixing units per wire |
Tensioner units per wire |
|
1 |
. |
. |
. |
. |
|
2 |
. |
. |
. |
. |
|
3 |
. |
. |
. |
. |
|
4 |
. |
. |
. |
. | | 
